background image

                        

 

9.  IMPORTANT SAFETY INSTRUCTIONS 

ϳ

  When replacing the batteries, use the same number and the same type of batteries. 

ϳ

  Do not dispose of batteries in a fire; the battery may explode. 

ϳ

  Do not open or mutilate the battery or batteries, released electrolyte is harmful to the skin and eyes. 

ϳ

  A battery can present a risk of electric shock and high short circuit current. The following 

precaution should be observed when working on batteries. 
* Remove watches, rings or other metal objects. 
* Use tools with insulated handles. 

ϳ

  To prevent an overbalance of this unit, with the installation the additional stabilizer are to mount at 

the bottom side. 

ϳ

  This unit is to be installed from service personnel. 

ϳ

  The equipment can be operated by any individual with no previous experience. 

ϳ

  “The socket-outlet shall be installed near the equipment and easily accessible.” 

ϳ

  “With the installation of this equipment it should be prevented, that the sum of the leakage current 

of the UPS an the connected consumer does not exceed 3.5mA.” 

ϳ

  Attention, hazardous through electric shock. Also with disconnection of this unit from the main, 

hazardous voltage still may be accessible through supply from battery. 

ϳ

  The battery supply should be therefore disconnected in the plus and minus pole through the from 

the outer enclosure accessible battery fuses when maintenance or service work inside the UPS is 

considered. 

ϳ

  The lead acid battery may cause chemical hazard. 

ϳ

  The battery presents a risk of electric shock and energy hazard. 

ϳ

  Batteries are to be disposed by the manufacturer or importer.      Customers need to send them 

back with no charge for disposal. 

ϳ

  Electrical hazard, the discharge time is about 5 min. 

 

German wording: 

ϳ

  Wenn Sie die Batterien austauschen, verwenden Sie bitte die gleiche Anzahl und den gleichen 

Batterietyp. 

ϳ

  Werfen Sie niemals die Batterien in das Feuer, die Batterien könnten explodieren. 

ϳ

  Öffnen oder beschädigen Sie nicht die Batterien, ausfile

β

endes Elektrolyt ist schädlich für Haut 

und Augen. 

ϳ

  Eine Batterie kann eine Gefahz eines elektrischer Schlages und sehr gro

β

er Kurzschlu

β

ströme 

beinhalten. Folgenda Vorkehrungen soiiten getroffen warden, wenn Sie mit der Battery arbeiten.
* Entfernen Sie Uhren, Ring and andere metallische Objekte.   
* Verwenden Sie Werkzeug mit isolierten Griffen. 

ϳ

  Um ein Umkippen dieses Gerätes zu verhindern, sind mit der Installation dieses Gerätes die 

zugätalichen Stützen an der Unterseite dieses Gerätes anzubringen. 

ϳ

  Dieses Gerät ist durch Elektrofachkräfte zu installieren. 

ϳ

  Bedienung durch jedermann ohne dem Vorkenntnisse. 

ϳ

  “Die Steckdose mu

β

 nahe dem Gerät angebracht und leicht zugänglich sein.” 

ϳ

  “Bei der Installation dieses Gerätes ist darauf zu achten, da

β

 die Summe der Ableitstöme der 

USV und der angeschlossenen Verbraucher den Maximalwert von 3.5mA nicht Überschreiten.” 

ϳ

 “Vorsicht, Gefahr durch elektrischen Schlag. Auch nach Trennung von der 

Netzeingangsspannung werde Teile innerhalb der USV von der Batterie gespeist und führen 

gefährliche Spannung. 

ϳ

  Bei Instandhaltungsarbeiten ist daher die Versorgung durch die Batterie an den von au

β

en 

zugänglichen Sicherungshaltern in beiden Polen zu unterbrechen.” 

ϳ

  Die Blei-Akkumulatoren Können bei unsachgemä

β

er Handhabung chemische Gefahren 

hervorrufen. 

ϳ

  Die Batterie birgt eine Gefahr eines elektrischen Schlages und sehr hoher Kurzschlu

β

stroeme. 

ϳ

  Batterien werden durch den Hersteller oder Importeur entsorgt. Dazu muessen die Batterien 

kostenfrei angeliefert werden. 

ϳ

  Gegahr durch elektrischen Schlag, die Entladeit dieser Kondensatoren beträgt 5 min. 

Summary of Contents for BS-1200











Reviews: