RST-100 INSTALLATION AND CONFIGURATION MANUAL
27
Settings Menu
Data / SIM Settings
Timeouts
Call Termination
The Call Termination parameter enables you to set how long to wait in minutes before
terminating a terminal initiated call if there has been no voice or data activity on the line for
the specified period of time. This field can be set to 0 to disable this feature and leave a call
up forever. The following parameters can fine-tune what ‘nothing heard’ means, allowing the
sensitivity and impulse immunity to be adjusted.
Data RX
Sets the wait Data RX
New feature only available on hardware Revision H.0 onwards.
This you to set enables how long to wait in seconds for characters on the Data port when in
AT command mode before reverting the RST to normal voice mode (so it can accept
incoming calls or make voice calls).
Once a Data call has connected this timer is ignored. ‘0’ disables this feature and will stay in
AT command mode forever as long as DTR remains high.