RST-100 INSTALLATION AND CONFIGURATION MANUAL
43
Message
Send Receive
This menu allows SMS messages to be sent to a phone or email destination, allows a Short
Burst Data message to be sent to the network programmed SBD destinations or the last
SMS received to be observed.
SMS destination
An International number format phone number (+ not required) or an email address for the
SMS destination. Note that two or more email destinations can be used for 1 SMS by putting
a ‘,’ delimiter between them. The total destination however must not exceed 50 characters.
Send SMS
Type in the SMS message followed by <cr>. The SMS will be sent to the SMS destination set
above. A maximum of 160 characters allowed, and a few ASCII characters are not supported in
the standard SMS alphabet (e.g. ~).