ENGLISH – Motorized screen user manual
Specifications are subject to change without notice. E&OE
Doc: Q Series – HOME CINEMA MODULES Installation Manual rev2 | 24.04 2013
Please verify that you are working with the latest revision of this document before specifying your screen.
Page 9
ILT2 MOTOR TYPE IDENTIFICATION –CHARACTERISTICS – ELECTRICAL CONNECTION
The type of motor installed on the product is identified by a label applied on each product showing the CE logo. When unwrapping the product please check the model type indicated on the label in order to
perform the installation and cable connections correctly. Should the power of the motor be different from that of the supply network of the installation place, please contact an electrician to have a current
and Hz transformer installed.
ELECTRICAL CONNECTION: electric cabling must be conformant with applicable IEC standards. IEC norm EN 60335-1 requires that supply network be fitted with an
omnipolar selector switch with contact opening distance of at least 3 mm.
For each motor (e.g. plug switch etc.). In case of need, this device ensures that the power supply is safely and quickly cut off.
Use the wires as described in the figure.
ATTENTION:
This product contains two motors, which must both be wired in the same manner.
WARNING: Correctly performed, state-of-the-art, norm-compliant electrical connections are important to prevent accidents and to ensure the screen’s optimal and
unaltered performance over time. Prior to carrying out any operation on electrical parts ensure that power supply is disconnected.
Bus cables (black white orange) must be insulated if not used for the push-button command.
In screens fitted with cases the motor is positioned on the right-hand side of the screen as seen from the front.
Operates with standard radio control (supplied).
Connection for each motor:
n
RJ 9 cable (to connect
with ILT4 interface)
o
Power supply cable (to
connect with 230V)
Motor characteristics
230V 50Hz:
Volt: 230V AC
Frequency: ~Hz50
Power: 90W
Torque: 6Nm
Speed: 17RpM
Max no. of cycles: 2
Operating T°: from –20 to +55 °C
Motor characteristics
120V 60Hz:
Volt: 120V AC
Frequency: ~Hz60
Power: 110W
Torque: 6Nm
Speed: 38RpM
Max no. of cycles: 2
Operating T°: from –20 to +55 °C
Interface characteristics
Power supplier:
90 ÷ 225 Vac 50/60 Hz
Protection class:
IP20 (of undamaged box)
Operating temperature:
0 ÷ 60 °C
Dimension / weight:
137 x 80 x 40 mm
12V Trigger
IR Sensor
RS485
Adapter RS232
+ = 5
30V
G = Ground
NC = Not connected
RS485 B
RS485 A
G = Ground
RS485 A = - RS232
RS485 B = + RS232
Transmission distance:
1000 meters/3281 feet
Page 3
Summary of Contents for HOME CINEMA MODULES Q Series
Page 1: ......
