Beamz 150.518, Instruction Manual

  - 7 - 

 
 
Setting Maximum Tilt Angles 

To select, use the “MODE/ESC” button and choose “t.9” or “t.18” “UP” and “DOWN” buttons cycle 
between all available Tilt Angles. Press the “ENTER” button to confirm the chosen selection. 

LED Display 

Maximum Tilt   

t.9 90º 
t.18 180º 

1-Built-in Program Mode (continued) 

As the unit can be mounted hung under earth trussing, or can sit equally well on a flat surface, pan, 
tilt and LED display settings can be reserved to provide correct coverage and ease of use. 

Setting Reversed or Normal Pan   

To select, use the “MODE/ESC” button and choose “Pan”(normal) or “r Pan” (reversed). “UP” and 
“DOWN” buttons cycle between the two settings. Press the “ENTER” button to confirm the chosen 
selection 

Setting Reversed or Normal Tilt 

To select, use the “MODE/ESC” button and choose “t.L” (normal) or “rt.l”(reversed).“UP” and 
“DOWN” buttons cycle between the two settings. Press the “ENTER” button to confirm the chosen 
selection 

Setting Reversed or Normal LED Display 

To select, use the “MODE/ESC” button and choose “d.s”(normal) or “rd.s”(reversed). “UP” and 
“DOWN” buttons cycle between the two settings. Press the “ENTER” button to confirm the chosen 
selection 

2-Auto Run Mode

One of two Auto Run Sub-modes can be selected with a choice of preset speeds .This mode enables 
the unit to act as a Master to other Slave units 
 

Choosing Auto Run Sub-modes 
To select, use the “MODE/ESC” button to show “NAFA” or “NASL”. “UP” and “DOWN” buttons 
change between the two initial options. With the appropriated option selected, use “ENTER” to 
confirm and the LED Display with change to: “Fast” (fast) or “SloU” (slow). The unit will then run at the 
chosen speed 
 

Initial LED Display 

Second LED Display 

Sub-mode 

NAFA Fast 

Fast 

Auto 

Run 

NASL SloU 

Slow 

Auto 

Run 

3-Sound Activated Mode 

The unit responds to sounds picked up by the unit in microphone to create a light show . Each sound 

picked up makes changes to color shown and position of the effects. This mode enables the unit to act 
a Master to other Slave units 
Choosing Sound Activated: 
To select, use the “MODE/ESC” button and choose “NStS”. When the “ENTER” button is pressed the 

LED Display changes to “SrUn” and the unit enters Sound Activated Mode. 

Initial LED Display 

Second LED Display 

Sub-mode 

NStS SrUn 

Sound 

Activated