1.3 AC Power
To determine the power requirements for a particular fixture, see the label affixed to the
back plate of the fixture or refer to the fixtures specifications chart. A fixtures listed current
rating is its average current draw under normal conditions. All fixtures must be powered
directly off a switched circuit and cannot be run off a rheostat (variable resistor) or dimmer
circuit, even if the rheostat or dimmer source voltage matches the fixtures requirement.
Check the fixture or device carefully to make sure that if a voltage selection switch exists
that it is set to the correct line voltage you will use.
Warning! Verify that the voltage select switch on your unit matches the line voltage
applied. Damage to your fixture may result if the line voltage applied does not
match the voltage indicated on the voltage selector switch. All fixtures must be
connected to circuits with a suitable Earth Ground.
1.4 Safety instructions
Please read these instructions cy. it includes important information about the installation.
usage and maintenance of this product.
•
Please keep this user guide for future
consultation.
•
If you sell the unit to another user, be
sure that they also receive this
instruction booklet.
•
Always make sure that you are
connecting to the proper voltage. and
that the line voltage you are connecting
to is not higher than that stated on the
decal or rear panel of the fixture.
•
This product is intended for indoor use
only!
•
To prevent risk of fire or shock, do not
expose fixture to rain or moisture. Make
sure there are no flammable materials
close to the unit while operating.
•
The unit must be installed in a location
with adequate ventilation. at least
20in(50cm) from
•
adjacent surfaces. Be sure that no
ventilation slots are blocked.
•
Always disconnect from pore source
before servicing or replacing fuse and
be sure to replace with same fuse size
and type.
•
Secure fixture to fastening device using
a safety chain.
•
Never carry the fixture solely by its
head.
•
Use its carrying handles.
•
Maximum ambient temperature (Ta) is
40°C. Do not operate fixture at
temperatures higher than this.
•
In the event of a serious operating
problem, stop using the unit
immediately.
•
Never try to repair the unit by yourself.
Repairs carried out by unskilled people
can lead to damage or malfunction.
•
Plesse contact the nearest authorized
technical assistance centre.
•
Always use the same type spare parts.
•
Don't connect the device to a dimmer
pack.
•
Make sure the power cord is never
crimped or damaged.
•
Never disconnect the power cord by
pulling or glugging on the cord.
•
Avoid direct eye exposure to the light
source while it is on.
