- 6 -
Maximum recommended serial data link distance: 500 meters (1640ft).
Maximum recommended number of fixtures on a serial data link: 32 fixtures.
Data cabling
To link fixtures together you must obtain data cables. If you choose to create your own cable
please use data-grade cables that can carry a high quality signal and are less prone to
electromagnetic interference.
3.3 3-Pin to 5-Pin conversion chart
Note! If you use a controller with a 5 pin DMX output connector you will need to use a 5pin to 3 pin
The chart below details a proper cable conversion:
3.4 Setting up a DMX serial data link
3.5 Master/Slave fixture linking
1. Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3pin connector of
the first fixture.
2. Connect the end of the cable coming from the first fixture which will have a (female) 3 pin
connector to the input connector of the next fixture consisting of a (male) 3 pin connector. Then,
proceed to connect from the output as stated above to the input of the following fixture and so on.
3.6 Orientation
This fixture may be mounted in any position provided there is adequate room for ventilation.
4. Operating instructions
4.1 Navigating the control panel
Access control panel functions using the four panel buttons located directly under the
Display.
4.2 Menu map
Six distinct operating modes, many with sub-modes, are supported by the unit. To selected use the
“MODE/ESC” button to enter the menu. “UP” and “DOWN” button choose from values available with
the “ENTER” button confirming any selection. After a few seconds, the LED Display will back during
operation until another button is pressed.
In –built Program Mode
4.3 User configurations
Setting Maximum Pan Angles
To select, use the “MODE/ESC” button and choose “PA18”, “PA36”,or “PA54”. “UP” and “DOWN”
buttons cycle between all available Pan Angles. Press the “ENTER” button to confirm the chosen
selection.
LED Display
Maximum Pan
PA18
180º
PA36
360º
PA54
540º
