18 / 32
REV. 01
•
The pack of pneumatic hoses must be connected into the control valve located under up/down
lever of the assist arm. Proceed to connect the blue, clear and black hoses as shown in the pictures below
•
Mount the side door back onto the machine and proceed to test the machine as described in the
following steps.
4.3
COMMISSIONING
Any electric connection job must be carried out by professional and
qualified personnel.
Make sure that the power supply is correct.
Make sure the connection of the phases is right. Improper electrical hook-up
can damage the motor and will not be covered under warranty.
•
Check to make sure t h a t the characteristics of your system corresponds to those required
by the machine. If you have to change the machine’s operating voltage, make the necessary
adjustments to the terminal board referring to the electric diagram in
chapter 9.
•
Connect the machine to the compressed air system.
