7
4 INCH CHIPPER
ENGLISH
ASSEMBLY
2.2 ASSEMBLY (CE COMPLIANT)
6.
With the chipper deflector weldment in the down
position (Figure 2.2), place discharge cap assembly
(15) onto the housing by aligning the bolt holes of the
discharge cap (15) and the bolt holes in the housing.
Place the two 3/8 x 5-1/2" bolts (16) through the bolt
holes. Secure by adding 3/8 flat washers (17) and
nylock nuts (5) to the 3/8 x 5-1/2" bolts (16).
Figure 2.3, Standard Configuration Discharge Cap
15
16
17
5
1. Mount the wheels to the axle as described in step 1
of Section 2.1.
2.
Attach the jack stand (1) to the hitch pole (2), as
shown in Figure 2.5, using 3/8 x 3" bolt (3) and nylock
nut (4). Attach the nylon lanyard (5) to the jack stand
(1) using 1/4 x 3/4" bolt (6) and 1/4" nylock nut (7).
Swing jack stand (1) up into the stored position and
secure by using the hitch pin (8) and cotter pin.
3.
Place hitch pole channel (9) in position underneath
trailer deck and mount to trailer deck using two 3/8 x
1" bolts (10) and 3/8-16 nylock nuts (4).
4. Now, insert hitch pole assembly into the mounted
hitch pole channel (9) making sure the end of the hitch
pole reaches the axle. Temporarily secure the hitch
pole assembly in place using two 3/8 x 3-1/4" bolts
(11), four 3/8 washers (12) and two 3/8-16 nylock nuts
(10) through the aligned mounting holes of the hitch
pole channel (9) and the hitch pole.
(Do not tighten
hardware securely until step 5 is complete.)
Figure 2.4, CE Compliant Hitch
1
2
3
4
5
6
7
8
Figure 2.5, Hitch Assembly
9
10
4
11
12
4
13
14 15
16
17
18
19
4
15
20
14
21
22
Figure 2.2, Chipper Deflector Weldment
