13
9 INCH CHIPPER
ENGLISH
FEATURES & CONTROLS
Mode Icons
Appears when the engine is at rest and the unit is in stop mode with no alarms active.
Appears when the engine is at rest and the unit is in auto mode with no alarms active.
Appears when the engine is at rest and the unit is waiting for a manual start with no alarms active.
Appears when a timer is active, for example cranking time, with no alarms active.
Appears when the engine is running, and all timers have expired with no alarms active. The animation speed
is reduced when running in idle mode.
Appears when the unit is in the front panel editor.
Warning Alarm Icons:
Warnings are non-critical alarm conditions and serve to draw the operator's attention to an undesirable condition.
Warning alarms are self-resetting when the fault condition is removed.
Warning Alarm Icons
Fail to Stop
Note: Fail to Stop could indicate a faulty oil pressure sensor. If the engine is at rest,
check oil sensor wiring and configuration.
The controller has detected a condition that indicates the engine is running when it has
been instructed to stop.
Charge Failure
The auxiliary charge alternator voltage is low as measured from the W/L terminal.
3.2 ENGINE CONTROLLER
A - STOP BUTTON
Pressing the button will shut down the engine or stop
auto-start.
B - AUTO BUTTON
Typical function is not used for this application. Pressing
the button will shut down the engine or stop auto-start.
C - START BUTTON
Pressing the button will begin the auto-start process.
D - MENU NAVIGATION BUTTON
Pressing the button will toggle between Engine RPM's,
Battery Voltage, and Engine Hours shown in the display.
E - MODE ICON
Icons indicating the engine state or the engine controller
operating mode are shown in the display.
F - FAULT LED
The indicator flashes when an Electrical Trip or Shutdown
Fault occurs.
