17
English
4. Buttons
Button
Function
MODE:
Press the "MODE/SET" button in the default screen to select
between the different display modes. You can choose between day
and seconds display, between the normal outdoor temperature and
the dew point as well as between the absolute (ABS) and relative
(REL) air pressure. If you do not press any button within 10 seconds,
the weather station switches back to the default screen.
SET:
Press and hold the "MODE/SET" button for about 5 seconds in
the default screen until "24Hr" flashes in the display. This takes you
to the basic settings.
MAX/MIN:
Press the "
MAX/MIN
" button in the default screen to
toggle between the maximum / minimum and current values. By
pressing and holding for about 2 seconds in the default screen, you
can toggle the temperature and air pressure unit between ° F and ° C
and between inHg (° F) and hPa (° C).
Minus (-):
Press the button to change the values in the settings.
CHANNEL:
Hold the button to delete the currently displayed values
of the outdoor sensor. The deletion is confirmed with a beep. The
weather station reconnects to the external sensor.
Plus (+):
Use the button to change the values in the settings.
SNOOZE/LIGHT:
Press the "SNOOZE/LIGHT" button to activate the backlight and to
choose between three different brightness levels.
Press and hold the "SNOOZE/LIGHT" button for about 5 seconds, to
turn off the backlight after 5 seconds of inactivity (OFF) or to turn it
on permanently (ON).
You can press the "SNOOZE/LIGHT" button as soon as the alarm goes
off to put the device in snooze mode for 5 minutes. The alarm goes
off once again after 5 minutes.
Summary of Contents for 303715/20190404SZ247
Page 67: ...67 Notes ...
Page 68: ...WD Plus GmbH Wohlenbergstraße 16 D 30179 Hannover ...
