28
English
7.2 Changing between heating and cooling mode
The device should not be active when changing the mode. The LED must be
switched off and the target temperature should not be displayed.
Proceed as follows to change between the heating mode (flame symbol) and
cooling mode (snowflake symbol):
1.
First press and hold the "UP" button and then press and hold the "ON/OFF"
button for about 4 seconds.
2.
The heating/cooling symbol changes in the display.
3.
Repeat the process until the desired symbol appears in the display.
8. Modes of operation (heating and cooling mode)
8.1 Heating mode
1.
Select the heating mode as described in section 7.2.
2.
Press the "ON/OFF" button to switch on the device.
3.
Set the desired target temperature (SET) using the "UP" and "DOWN"
buttons.
4.
The thermostat switches on when the room temperature (RM) is below
the set target temperature (SET). The LED changes from red to green after
about 1-3 minutes. This means that the thermostat is active (heating mode
is switched on/socket is active).
5.
Once the room temperature (RM) reaches the target temperature (SET),
the thermostat switches off and the status LED changes back to red.
Heating mode (e.g., for heaters)
Cooling mode (e.g., for air conditioners)
