29
English
8.2 Cooling mode
1.
Select the cooling mode as described in section 7.2.
2.
Press the "ON/OFF" button to switch on the device.
3.
Set the desired target temperature (SET) using the "UP" and "DOWN"
buttons.
4.
The thermostat switches on when the room temperature (RM) is above
the set target temperature (SET). The LED changes from red to green after
about 1-3 minutes. This means that the thermostat is active (cooling mode
is switched on/socket is active).
5.
Once the room temperature (RM) reaches the target temperature (SET),
the thermostat switches off and the status LED changes back to red.
9. Factory settings
To reset the device to factory settings, press the "RESET" button at the top of the
device.
10. Cleaning Instructions
Clean the thermostat with a dry cotton cloth. Make sure that the product is
switched off and completely disconnected from the mains. Never use any chem
-
ical cleaning agents. Never use liquids which could damage the surface of the
product such as scouring milk.
11. Safety instructions and disclaimer
Never try to open the device to repair or make modifications. Avoid contact with
the mains voltage. Do not short-circuit the product. The device is not waterproof,
hence please use it only in dry surroundings. Protect it from high humidity, water
and snow. Do not expose the device to high temperatures. Do not expose the
device to sudden changes in temperature or strong vibrations, as this could dam
-
age the electronic components. Check the device for any damage before using it.
The device should not be used if it was subject to impact or has been damaged in
some other manner. Please comply with the local regulations and restrictions. Do
