18
While riding your Hover-1 Beast, if there is a system error or illegal
operation performed the device will prompt the user in a variety of
ways.
You will notice the Running Indicator Light will turn RED and you will
hear a beep sound alerting you to take precaution and cease
operation, which may make the device stop suddenly.
The following are common occurrences where you will hear the
Safety Alerts. These notices should not be ignored, but
appropriate action should be taken to correct any illegal
operation, failure or errors.
• Unsafe riding surfaces (uneven, too steep, unsafe, etc.)
• When you step on the device, if the platform is tilted more than 17
degrees forward or backward.
• Battery voltage is too low.
• The device is still charging.
• During operation, the platform self initiates to tilt due to excess speed.
• Overheating, or motor temperature is too high.
• The device has been rocking back and forth over 30 seconds.
• If the system enters protection mode, the alarm indicator will light
up and the board will vibrate. This typically occurs when the battery
is about to run out of power and stop abruptly.
• If the platform is tilted forward or backward more than 17 degrees,
Hover-1 Beast will power off and stop suddenly, possibly causing the
rider to lose balance or fall off.
• If any or both tires are blocked, the device will stop after 2 seconds.
• When the battery level has depleted below protection mode, the
device engine will power off and stop after 15 seconds.
• While sustaining a high discharge current during use (such as driving
up a steep slope for a long period of time), the device engine will
power off and stop after 15 seconds.
WARNING
When the Hover-1 Beast turns off during a
Safety Alert, all operation systems will halt.
Do not continue attempting to ride the
Hover-1 Beast when the system initiates a
stop. Turn your Hover-1 Beast off and
back on to unlock it from a Safety Lock.
