Beat-Sonic TVK-10 Installation Instructions Manual Download

Page: 2 / 4

2. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (w/o Smart Key System)

(a) Apply protective tape to the areas shown in the illustration.

(b) Using a molding remover, disengage the 10 claws and 8 clips starting from the upper part of the center
instrument cluster finish panel assembly.

NOTICE: Do not pull on the small storage compartment lid. Doing so may cause damage.

3. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (w/ Smart Key System)

(a) Apply protective tape to the areas shown in the illustration.

(b) Using a molding remover, disengage the 10 claws and 8 clips starting from the upper part of the center
instrument cluster finish panel assembly.

NOTICE: Do not pull on the small storage compartment lid. Doing so may cause damage.

Summary of Contents for TVK-10

Page 1: ...d on the factory harness and this is 100 plug and play it is easily reversible to the original factory specs without showing any signs that this modification was ever made The TVK 10 modules are equip...

Page 2: ...se damage c Disconnect each connector and remove the center instrument cluster finish panel assembly 3 REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY w Smart Key System a Apply protective tape...

Page 3: ...e heater control and accessory assembly b Disconnect the connector 5 REMOVE AIR CONDITIONING CONTROL ASSEMBLY for Automatic Air Conditioning System a Disengage the 4 clips and remove the air condition...

Page 4: ...of the TVK 10 connector 10 Find the matching 1 pin GPS connector located behind the screen and disconnect it 11 Connect the 1 pin connector on the TVK 10 to the same place where the factory 1 pin GPS...