Safety instructions and warnings
14/60
Setup location
WARNING!
Salty air! Contaminated air!
Device damage due to corrosion of the housing and electri-
cal components.
–
Do not install the device at swimming pools.
–
Do not operate the device in locations with aggressive
environmental conditions (e.g. air containing chlorine)
Damage to device possible!
Where there are great differences in temperature between
the transport route and the installation site the device may
not be put into operation immediately after being set up.
–
Wait at least 2 hours before connecting the device to
the power supply.
Risk of overheating due to air flow problems!
Operating faults possible.
–
Do not change, obstruct or block the air inflow and
outflow to the device or make any unauthorized chang-
es to the device. The manufacturer shall bear no liability
for damage or injuries resulting from such actions.
–
Observe the ventilation system data.
–
Do not set up and operate the device on the transport
pallet!
Environmental conditions
Optimum ambient temperature: Between 15 °C and 32 °C
Storage temperature: Between -15 °C and +60 °C
The device is not to be used outdoors.
A suitable connector for the power supply must be available, see the technical
data on page 54.
Adaptation of the unit is required for operating altitudes greater than 2000 m
above sea level in order to guarantee trouble-free operation.
The device is not suitable for operation in mobile facilities (ships, buses,
trains). Adaptation of the unit is required in order to guarantee trouble-free
operation when used in mobile facilities.
Please contact the customer service department without fail before putting the
device into operation - see page 2.
