Cosmetic face device BeautyRelax BR-1280
User Manual
12
HOW TO USE
1.
Wash skin thoroughly before each use. Ideally, the timing of treatment after the bath.
2.
Apply a fine layer of clear application gel (not included) to the treated area. You can buy the
application gel, the so-called SONOGEL, in any medical shop (also available in a pharmacy).
Gel is very important for the use of the device. It forms the necessary binding layer between
the application head and the skin. It is made on a water basis. It cannot damage the
application head. Use of an application gel is essential. We do not recommend a device
without a binding agent between skin and applicator. This would unnecessarily reduce
efficiency. See page: DIAGRAM OF USING AUTOMATIC PROGRAMS.
3.
Press and hold
MODE / ONOFF
. The device has 5 automatic programs that have preset
individual technologies of skin treatment.
4.
CLEAN
mode is automatically activated as soon as it is started.
5.
Press the
MODE / ONOFF
button again to
MOISTURE
mode.
6.
Press the
MODE / ONOFF
button again to select
EMS UP
mode.
7.
Press the
MODE / ONOFF
button again to select the
RF LED
mode.
8.
Press the
MODE / ONOFF
button again to select
COOL
mode.
9.
Use the
LEVEL
button to set the power of the device to suit your exact needs. There are 5
intensity levels to choose from.
10.
The backlight display shows basic information about the course of treatment. You can check
the level of exposure and the progress of the device.
11.
Each automatic program will switch off automatically after 3 minutes.
12.
You can switch the device off at any time by long pressing the
MODE / ONOFF
button.
Note:
Each automatic program has a timer that automatically turns off the unit after 3
minutes of operation.
Note:
Always keep the low level on for the first skin contact. Place the applicator on the part
of your face where there is more subcutaneous fat. You can gradually increase your strength.
However, it always depends on your subjective feeling. If the treatment is already unpleasant
to slightly painful, set back to the lowest level or stop the treatment.
Tip:
The treated face and neck area should ideally be free of significant thick hair. This will
improve the movement of the applicator head over the skin. In particular, radio frequency
waves will be better able to penetrate the subcutaneous tissue.
Recommendation:
If you are using radiofrequency function and EMS with a higher intensity
level, do not expose the treated skin to hot water for at least 3 days. The skin undergoes
convalescence treatment and hot water (or a sauna stay) can irritate the skin unnecessarily.
The skin gets warm when you use the machine. If you feel too warm, take a break and let the
skin cool down.
