Cosmetic face device Beautyrelax BR-2090 EMS HOT&COLD
User manual
20
SOLVING POTENTIAL PROBLEMS
The Problem
Possible cause
Solution
The action of EMS electrical
pulses is too strong.
The intensity setting is too strong. Reduce the intensity to a lower level
or to the basic lowest level 1.
The application head is not in full
contact with the skin.
Press the applicator head fully
against the skin.
The skin is poorly moisturized.
Add a larger amount of contact gel
to the skin.
The action of EMS electrical
pulses is too weak.
The intensity setting is too low.
Increase the intensity to a higher
level. Increase gradually by one
degree only.
The skin is poorly moisturized.
Add a larger amount of contact gel
to the skin.
I do not feel the effect of EMS
electrical pulses on my skin.
The application head is not in full
contact with the skin.
Press the applicator head fully
against the skin.
The movement on the skin is too
fast.
Slow down the movement of the
applicator on the skin.
The intensity setting is too low.
Increase the intensity to a higher
level. Increase gradually by one
degree only.
The skin treatment program is
supposed to generate heat, but I
don't feel any heat.
The device automatically shuts
down or returns to standby
mode.
Switch the device off and on again
using the ON/OFF button.
Your skin is too dry.
Add a larger amount of contact gel
to the skin.
The movement on the skin is too
fast.
Slow down the movement of the
applicator on the skin.
