8
Instructions for use
• No alterations may be made to the Bébé Confort Priori Side Protection System (SPS+) as this could affect part or the
overall safety of the seat.
• In hot weather the plastic and metal parts of the Bébé Confort Priori Side Protection System (SPS+) may feel hot to the
touch. You should therefore cover the seat if the car is parked in the sun.
• In order to prevent damage to the cover, do not remove the Bébé Confort Priori Side Protection System (SPS+) logo.
• Use the seat even on short journeys as this is when most accidents occur.
• Prior to purchase check that the seat fits properly in your car.
• Take short breaks on longer journeys so that your child has some freedom of movement.
• Set a good example yourself and always wear your seat belt.
• Tell your child that he/she should never play with the belt buckle.
Questions
Contact your supplier or importer if you wish to make a warranty claim or have any other questions (see address list on
the back of the instruction manual).
The seat belt
The Bébé Confort Priori Side Protection System (SPS+) should be used with an automatic 3-point safety belt provided that
this has been approved according to ECE R16 or an equivalent standard. Do not use with a 2-point safety belt.
• Your Bébé Confort Priori Side Protection System (SPS+) can be fitted safely on almost all the seats in the car with the
existing seat belts. However, on some seats the belts are fitted so far forward that proper installation is not possible.
If this is the case, try another seat.
• In some cases the buckle of the car belt may be too long and therefore sits too high against the base of the Bébé Confort
Priori Side Protection System (SPS+). Thus, the Bébé Confort Priori Side Protection System (SPS+) cannot be fitted
securely. If this is the case, choose another position in the car.
Four positions of the Bébé Confort Priori Side Protection System (SPS+) (A)
The Bébé Confort Priori Side Protection System (SPS+) may be used in four positions: Lift the handle under the front of
the seat up and pull or push the shell forwards or backwards. Release the handle in the required position and push until
you hear a distinct click.
Installing the Bébé Confort Priori Side Protection System (SPS+) with a 3-point safety belt (A-B)
When installing the car seat follow the installation instructions for the 3-point safety belt described above
(under section “the seat belt”).
A 3-point safety belt is shown in figure B.
Place the Bébé Confort Priori Side Protection System (SPS+) in the sleeping position (A) on the car seat.
Thread the seat belt between the shell and base (B1).
Fasten the seat belt in the belt buckle (B1).
The lap belt now fits under the red hooks and the shoulder belt runs from the belt buckle directly diagonally upwards.
Place the shoulder belt in the belt clamp on one side only (B2) and fasten it (B3-1). Note! The shoulder belt is now
only attached on the side of the roll-up mechanism.
Push the Bébé Confort Priori Side Protection System (SPS+) firmly into the car seat and pull the shoulder belt tight (B3)
so that there is no play between the car seat and the Bébé Confort Priori Side Protection System (SPS+).
Check this!
Pull the shoulder belt through the top belt hook (B4).
Placing your child in the Bébé Confort Priori Side Protection System (SPS+) (C)
Loosen the shoulder belts by pressing the release button and pulling the shoulder belts towards you (C1). Note! Do
not pull on the belt pads.
Open the belt buckle (C2) and drape the belts over the hooks on the shell (C3).
EN
