Before assembly, remove the plastic pieces on each side of
the pole, and the plastic protective ring on the pole
Please note – Make sure the white plastic ring on the pole is firmly
pushed down each time the height has been
adjusted
.
HIGH CHAIR ASSEMBLY
1.Align Notch in bottom of metal pole with rotation button in
base.
2.While pressing the rotation button on base, push metal pole
downwards until fully inserted into base. Release button.
3.Lie assembly on its side and screw three (x3) screws with
washers into base to secure metal pole to the base.
!Ensure
metal pole is locked into base by gently pulling up on it.
To remove:
Unscrew three (x3) screws under base, press
rotation button to lift metal pole out of base.
4.Stand assembly upright and find the locking pin located at the
top of the metal pole. Press the locking pin while sliding seat
onto metal pole to lock into place.
5.Ensure locking pin locks in place through hole in seat base.
Gently pull up seat to ensure it is secured.
6. Attach footrest by sliding it up into opening on bottom of seat
base.
Ensure footrest is locked into place by gently pulling down.
PLEASE NOTE: THERE MAY BE A PLASTIC ORANGE/GREEN RING
ON THE POLE – THIS NEEDS TO BE REMOVED!
USING HIGHCHAIR
WARNING!
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN
Summary of Contents for PSDH72
Page 2: ......
