bebeduE Beyond GR016-15V1, Manual

STEPS PRIOR TO INSTALLING THE BEBÉDUE BEYOND CHILD SAFETY SEAT

This group 0+ seat must only be installed in a BebéDue Beyond pushchair.

First open the pushchair chassis and engage the rear wheel brakes.

INSTALLING THE GROUP 0+ SEAT IN THE PUSHCHAIR CHASSIS (Fig. 2)

Position the group 0+ seat on the chassis. It should be aligned so that the chassis mountings are 

in line with the corresponding group 0+ seat mountings. Fit the group 0+ seat into the chassis, 

making sure that both mountings have made a “click” sound, indicating that they are correctly 

in place. 

You can check correct installation by lifting up the group 0+ seat; if it is correctly installed, the 

chassis will lift up along with the seat. 

UNINSTALLING THE GROUP 0+ SEAT FROM THE PUSHCHAIR CHASSIS (Fig. 3)

Lift the levers situated on the mountings of the group 0+ seat while simultaneously pulling 

upwards to release the seat.

IMPORTANT: Always perform this operation when the baby is not in the 

group 0+ seat.

FASTENING THE SAFETY BUCKLE ON THE GROUP 0+ SEAT (Fig. 4)

A. Fit together the two parts of the buckle connectors.

B. Fit the two chest buckle connectors into the slot on the top of the central buckle. Always 

check that the harness has been fastened correctly by pulling the shoulder straps upwards. 

C. To unfasten the harness, press the red button on the buckle. 

ADJUSTING THE HARNESS (Fig. 5 and 6) 

Lift the shoulder straps to tense the waist section of the harness and then pull the 

adjustment strap until the harness is completely tense (Fig. 5). 

You should adjust the harness as much as is possible while ensuring that the child is not 

uncomfortable. 

Ensure that the waist strap of the harness is below the child’s stomach, as close as possible to 

the thighs. If the harness is loose, this may be dangerous. Check that the harness is correctly 

adjusted and adjust it whenever the child is placed in the seat.

In order to loosen the harness, press on the point marked “Press” while supporting the two 

shoulder straps with your other hand. Pull the shoulder straps towards you to loosen the 

harness (Fig. 6).

CORRECT HEIGHT FOR THE SHOULDER STRAPS (Fig. 7)

The harness has 2 height positions.

Always check that the shoulder straps are at the right height for the child.

The child’s shoulders must always be below the harness slot used.

EN