Device Configuration /
Interface Setup
59
BEC 9800VN User Manual
keys for your selection. The input format is in HEX style, 5 and 13 HEX codes are required for
64-bitWEP and 128-bitWEP respectively.
If you chose
WEP 64-bit
, then enter any 5 ASCII characters or 10 hexadecimal characters ("0-9",
"A-F").
If you chose
WEP 128-bit
, then enter 13 ASCII characters or 26 hexadecimal characters ("0-9", "A-F").
You must configure all four keys, but only one key can be activated at any one time. The default key is
key 1.
Note:
When you enable
WPS
function, this
WEP
function will be invalid. And if you select one of
WEP-64Bits/ WEP-128Bits,
the following prompt box will appear to notice you.
WPA-PSK & WPA2-PSK
WPA Algorithms:
TKIP (Temporal Key Integrity Protocol) or AES (Advanced Encryption System)
utilizes a stronger encryption method and incorporates Message Integrity Code (MIC) to provide
protection against hackers.
Pre-Shared key:
The key for
network authentication. The input format should be 8-63 ASKII
characters or 64 hexadecimal characters
Key Renewal Interval:
The time interval for changing the security key automatically between wireless
client and AP.
WDS Settings
WDS (Wireless distributed system) is a wireless access point mode that enables wireless link and
communication with other access point. It is easy to be installed, just define the peer’s MAC of the
connected AP.
WDS Mode:
select Activated to enable WDS feature and Deactivated to disable this feature.
MAC Address:
Enter the AP MAC addresses (in XX:XX:XX:XX:XX:XX format) of the peer connected
AP.
