18
Assembly and Operating Instructions
The SC211 is designed solely for the operation of folding arm awnings. It can be
integrated in an open awning, in a half cassette or a fully closing cassette awn-
ing. For safety reasons, the SC211 may only be operated with one sun protection
drive with integrated radio receiver. The operation of two or more awnings with
one SC211 is not permitted.
The SC211 is compatible with the Centronic SunWindControl SWC241 hand-
held transmitter. The use of other sun protection controls from the Centronic
range to operate the SC211 is not recommended.
Using the SC211 for other purposes or for purposes beyond the above
constitutes improper use.
• Please note that radio-controlled systems may not be used in areas with a
high risk of interference (e.g., hospitals, airports).
• The remote control is intended solely for use with equipment and systems in
which malfunctions in the hand-held transmitter or receiver would not pose
any risk to persons, animals or property or which contain safety devices to
eliminate such risks.
• The operator is not protected from interference from other telecommuni-
cations systems and terminal equipment (e.g., even from radio-controlled
systems which are properly operated in the same frequency range).
Note
Radio-controlled systems transmitting on the same frequency may
cause reception interference.
Note that the range of the radio signal is limited by legislation as well
as by design.
Intended use
