60
>>>
NAVIGATION MODE
Selecting a destination from the map
You may also select a destination directly
from the displayed map.
>
Press the
Select on map
button.
The map display appears.
>
Press the desired point lightly on the
surface of the screen.
A flashing red cross will be displayed at
this point.
>
Press the
Select
button.
Where available, the address of your
chosen point is displayed.
>
Press the
Start
button to begin route
guidance to the destination straight
away.
You can also search for points of interest
in the vicinity of your chosen point using
the POI nearby button.
However, you can also store your
chosen point in fast access mode (
Save
)
or display the route to the point of
interest (
Show route
).
You can select a new destination by
touching the map even during the route
guidance in progress, in order to insert a
stopover or to replace the old
destination. When touching the display, a
compass appears with arrows to adjust
the horizontal display and the vertical
display angle of the map. This function is
described on page 97.
Note:
You may need to make the area larger
using the zoom buttons
and
in
order to find the desired point. You can
also move the map to the desired point.
Note:
By pressing the
GPS Position
you can
display your current position again.
