50
Assembly and Operating Instructions
What to do if ...?
Problem
Cause
Remedy
Drive is not function-
ing.
1. Batteries are dead.
2. Batteries are incor-
rectly inserted.
3. Receiver outside the
radio range.
4. Transmitter is not
programmed in the
receiver.
1. Insert new batteries.
2. Insert batteries cor-
rectly.
3. Reduce distance to
the receiver.
4. Programme transmit-
ter.
The transmitter does
not react after the
batteries have been
changed.
Power supply has been
interrupted for too long.
Press the RESET button.
Check settings.
The word BATTERY is
displayed.
Battery power is low.
Replace batteries.
The required drive is
not functioning.
Incorrect channel
selected.
Correct channel se-
lected
Curtain/fabric does
not move into the end
position.
End position is not set.
Set end position in
setting menu SUN END
POSITION or TIME END
POSITION.
Automatic control
commands are not
executed.
1. Sliding switch not in the
“
“ position.
2. Winter setting is set to
ON.
3. The automatic sun
protection function
was interrupted by a
manual command.
1. Set sliding switch to the
“
“ position.
2. Set winter setting to
OFF.
3. Turn the sliding switch
from “
” to “
” and
back to “
”.
The system is not
extended automatically
when the sliding switch
is set to “
“.
1. Sunlight intensity is
below the threshold
value.
2. Wind speed exceeds
threshold value.
1. Adjust sun threshold
value.
2. Wait until wind abates.
Summary of Contents for Centronic SunWindControl SWC545-II
Page 100: ...4033 630 204 0a 03 10 310322 01 ...