fr
en
de
nl
37
END LIMIT
The end limit is the point the sun protection system reaches when fully retracted
or extended.
INTERMEDIATE POSITION
The intermediate position lies between the (retracted and extended) end limits
of the sun protection system and can be freely selected. The sun protection
system is moved into this position from the retracted end limit position after
programming.
To do so, press the EXTEND button twice in rapid succession.
When the system is in venetian blind mode, a reverse control command will be
automatically executed following the extend control command, provided a re-
verse position has been pre-set.
CANOPY TENSION/REVERSE
The canopy tension/reverse position lies between the (retracted and extended)
end limits of the sun protection system/venetian blind and can be freely se-
lected. This function allows you to pull your awning canopy taut.
In the case of venetian blinds, the blind slats are turned.
To do so, press the RETRACT button twice in rapid succession.
WINTER OFF/ON
If the WINTER ON function has been activated, no automatic and manual control
commands are executed.
WIND CONTROL
The wind threshold value is pre-set to 04.
The wind threshold value can be set to values ranging between 01 (slight winds)
and 11 (strong winds).
The existing wind setting and the new setting to be made are shown on the dis-
play. The new wind setting field flashes.
If the wind setting has not been reached for a period of 15 minutes, control com-
mands may be executed again.
TEST mode
Press and hold the OK button for approx. 5 seconds to activate the TEST
mode.
The TEST mode is used to check whether the sensory equipment is functioning
properly. When the TEST mode is active, the word TEST appears on the dis-
play.
In the TEST mode the pre-set delay times are shortened
Language selection (ENGLISH GB)
Your national language can be selected via this menu option.
Summary of Contents for Centronic SunWindSet SWS42
