-10 mm
To ensure secure torque transmission for
round shafts
, we recommend screwing the drive adapter to
the shaft (see the table below).
Attention! When drilling into the barrel, never drill near the tubular drive!
Size of drive
[mm]
Drive adapter
Torque
max. [Nm]
Fastening screws
(4 units)
dia. 35-dia. 45
All
Up to 50
Self-tapping screw
dia. 4.8 x 9.5 mm
We also recommend screwing the idler to the barrel.
Attention
Do not hammer the tubular drive into the tube or drop it into the barrel! The curtain can only
be secured using springs or rigid shaft connectors. We recommend at least three pieces
per metre of barrel.
2
1
Assemble the tubular drive with the relevant ring (1) and drive adapter (2). If the ring has several
grooves, select the groove which is a perfect fit and push the ring (1) onto the thrust ring.
Insert the tubular drive with the pre-assembled ring (1) and drive adapter (2) into the tube to achieve a
form fit. Ensure that the ring and drive adapter are secure in the tube.
Mount the assembled unit comprising shaft, tubular drive and idler on the box and secure the drive with
a splint or spring pin according to the type of wall bracket fixing.
Automatic setting of limit positions is possible, where a stop system is present on both sides, using the
rotary switch set (Item no. 4901 001 158 0), a standard rotary switch or the programming unit for drives
with electronic limit switching (Item no. 4935 200 011 0). All other functions can only be set via the pro-
gramming unit.
Connect the wires of the tubular drive to those of the same colour in the programming/operator control
and switch on the power supply.
Attention
The rotary switch and the programming unit are only designed for the commissioning, and
not for continuous operation!
Position the barrel so that the roller shutter curtain can be attached with springs or fit the rigid shaft connectors in accordance with
the manufacturer's instructions.
Lay the connecting cable
Lay the connecting cable up to the tubular drive, and fix The connecting cable and any antennae must
not project into the winding chamber. Cover any sharp edges.
8 - en
