Intermediate positions I + II
The intermediate positions I + II are freely selectable positions for the shading solution
between the two limit positions. Each travel button can be assigned one intermediate posi-
tion. Both limit positions must be set before an intermediate position is set.
Setting the desired intermediate position
Use a short drive command to move the shading solution in the direction of the de-
sired intermediate position.
5s
At the desired intermediate position, press the corresponding travel button while
moving for 5 seconds.
▻
The tubular drive confirms.
►
The intermediate position is now saved.
Travelling to the desired intermediate position
2x
2x
<1s
Press the travel button for the desired intermediate position twice within one second.
►
The curtain runs to the intermediate position assigned to the travel button.
Deleting the desired intermediate position
5s
Press the travel button assigned to the intermediate position for 5 seconds.
▻
The shading solution moves to the intermediate position and the tubular drive
confirms.
►
The intermediate position is now deleted.
Programming additional transmitters
Up to 14 transmitters can be programmed into the tubular drive.
Put the tubular drive into programming mode.
3x
3x
<2s
Press a travel button 3 times within 2 seconds on the transmitter to be programmed.
▻
The tubular drive confirms.
►
The new transmitter has now been programmed.
Programming of window handles with EnOcean wireless technology
Put the tubular drive into programming mode.
<2s
1.
2.
Move the window handle from the CLOSED position to OPEN and back to CLOSED
within 2 seconds.
▻
The tubular drive confirms.
►
The window handle has now been programmed.
17 - en
Summary of Contents for enocean P5-16
