Becker enocean P5-16, Assembly And Operating Instructions Manual

Obstacle detection

Caution

Obstacle detection is only active in conjunction with the "drive adapter for obstacle detec-

tion".

In addition, please note that the drive must be pushed in to the shaft as far as the band of

the thrust ring.

Use of the drive’s obstacle detection system as personal protection is not permitted. It has

been designed exclusively to protect the roller shutters or sun protection system from be-

ing damaged.

If the drive is correctly installed, it switches off when it detects obstructions or shutter faults and reverses a short way in the oppos-
ite direction and thus away from the obstacle.
If reversing is interrupted, a further drive command is only possible in the direction of reversing. Travel the shading solution without
interruption until the tubular drive stops automatically. It is now possible to travel in both directions again.

The following are detected:

Moving DOWN

•

A curtain jam when closing due to objects on the window sill or sticking of the lateral guide tracks.

To ensure complete closing of the roller shutter curtain at the lower limit position, the curtain does not reverse once it gets to ap-
prox. 360° from the lower limit position.
To ensure that the roller shutter curtain safely enters the guide tracks, obstacle detection is inactive for approx. 1.5 revolutions of
the barrel from the upper limit position.

Moving UP

•

Extremely large increase in the load (e.g., ice on the end strip)

Possible configurations with the Remote Commissioning Software

Please find the appropriate description in the instructions for the software.

•

Upper anti-freeze mechanism

•

Fly screen protection function

•

Repeater mode Level 1 and Level 2

•

Lock-out protection

•

Programming smoke alarm

•

Activating / deactivating the programming mode by switching on the power

•

Set tubular drive to installation mode

•

Running direction

19 - en