SAR-DF 517
DV 77513.03 Issue 4 09/2006
Page 2-1
Section
2
Installation
2.1
General
The installation of the display unit and antenna unit depends on the type of aircraft and equipment
and therefore only general information can be given in this section.
2.1.1.
Inspection before installation
Place the packed unit on a clean, flat surface. Open the reusable package, carefully remove the units
and check for completeness. Replace the packaging material in the shipping container and keep it so
that the unit can be properly repacked for storage or shipping.
Before installing the dispaly unit and antenna unit in an aircraft, carry out a visual inspection for any
transit damage, paying particular attention to the following:
Dirt, dents, scratches, corrosion, broken attaching parts on the housing and housing parts.
Dirt and scratches on the identification plate, front panel, LC display and marking.
Dirt, bent or broken pins, cracked connector inserts.
Dirt and mechanical damage on the rotary switches, push-buttons and knobs.
Missing screws.
If damage is found, immediately inform the carrier.
2.2
Mechanical installation display unit
The display unit is designed for installation in the instrument panel or operating console of an aircraft.
The necessary dimensional details are given in Fig. 2-1 and Fig. 2-2.
