22
>>>
GERNERAL OPERATION
> EN
The card slot is located on the left side of
the unit. The card slot is equipped with a
spring-actuated locking and ejector me-
chanism.
Inserting the memory card
>
Remove the memory card from its
packaging without touching or soiling
the contact bar.
>
Hold the memory card such that the
contact bar faces toward the rear of the
unit.
>
Guide the memory card into the card
slot.
>
Exert a little pressure and slide the
memory card into the card slot until it
snaps in.
Ejecting the memory card
The card slot ejects the card so that you
can pull it out with two fingers.
>
Use your finger to gently press the
memory card against the spring force
into the card slot and then release it.
The card is ejected.
>
Remove the memory card and place it
in the packaging while ensuring not to
touch contact bar.
Note:
A small slider is located on one side of the
card. If this is pushed in the direction of
the arrow, the Memory Card is protected
from being overwritten.
NOTICE
The memory card should only be insert-
ed or ejected when the unit is switched
off. If the unit is not switched off, data
may be lost.
Navigational operations are not possible if
the memory card containing card data is
not inserted. If you remove this during
navigation, directions to your destination
will be aborted immediately.
Summary of Contents for TRAFFIC ASSIST
Page 1: ...Instructions for Use ...