29
> EN
GERNERAL OPERATION
>>>
Adjusting the unit bracket
The support plate (6) can be swung in two
directions (horizontally and vertically). It
can thereby be set at virtually every angle
of vision to the driver.
Vertical movements
>
Loosen the fastening screw (2) far
enough to be able to swivel the carrier
plate (6) downward from above without
using excessive force.
>
Hold the base (5) with one hand and
swivel the carrier plate (6) to the desired
position with the other hand.
>
Tighten the fastening screw (2) suffi-
ciently so that the Traffic Assist is held
securely in place when the vehicle is in
motion.
Horizontal movements
>
Loosen the fastening screw (1) far
enough to be able to swivel the carrier
plate (6) from left to right without ex-
erting excessive force.
>
Hold the base (5) with one hand, and
swivel the carrier plate (6) to the desired
position with the other hand.
>
Tighten the fastening screw (1) suffi-
ciently so that the Traffic Assist is held
securely in place when the vehicle is in
motion.
Adding the Traffic Assist
The Traffic Assist is equipped with four
guides and the carrier plate (6) has corres-
ponding retaining lugs.
>
Position the Traffic Assist with the gui-
des on the carrier plate retaining lugs
(6).
>
Push the Traffic Assist downward to the
stop.
>
Position the Traffic Assist with the at-
tachment points on the bottom of the
housing on the carrier plate (6).
>
Press the Traffic Assist onto the carrier
plate (6) without using excessive force
until the clip (7) engages in the attach-
ment point.
Removing the Traffic Assist
Press the clip (7) on the unit holder with
one finger and remove the unit from the
unit holder using your free hand.
Note:
Do not swing the support plate in both
directions at the same time! Before mov-
ing, always take the Traffic Assist off the
unit bracket.
Summary of Contents for TRAFFIC ASSIST
Page 1: ...Instructions for Use ...