BECKER VADS 1500+
15
DANGER
Danger to life due to electric shock
There is an immediate danger to life in case of contact with live parts. Damage to the insulation or individual
components can be life-threatening.
Therefore:
•
If the insulation is damaged, switch off the power supply immediately and arrange for repairs.
•
Only allow work on the electrical machine to be carried out by qualified electricians.
•
Whenever working on the electrical machine, disconnect it from the power supply and check that it is not live.
•
Before maintenance, cleaning and repair work, switch off the power supply and secure it against being
switched on again.
•
Do not bypass or disable fuses. When replacing fuses, observe the correct amperage.
•
Keep moisture away from live parts. This can lead to a short circuit.
DANGER
Danger to life due to electric shock
To perform tasks and activities on the electrical system of the VADS 1500+, work must be carried out in ac-
cordance with the five safety rules.
1. Isolation
2. Secure against restarting
3. Determine and document absence of voltage
4. Grounding and short-circuiting
5. Cover or fence off adjacent live parts
DANGER
Danger to life due to electric shock
The following steps are mandatory when preparing for maintenance and servicing activities:
1. Switch off the VADS 1500+ and all attached assemblies.
2. Switch off the power supply and secure it against unintentional reconnection, or disconnect the drive from
the supply voltage.
WARNING
Risk of injury from slipping, tripping and falling
Obstacles and danger spots, especially exposed floor slabs and with coolants and lubricants contaminated
areas, shall be clearly marked.
The obstacles and danger points are to be provided with a sturdy double-sided warning sign that is
contains the warning „Caution - danger of slipping“ or „Caution - danger of falling“ in text and as a symbol.
Large danger areas must be secured with barrier tapes, chain barrier systems and warning cones. The operator
of the machine is responsible for ensuring road safety.
WARNING
Danger due to high temperatures
During operation, media and machine parts can reach high temperatures. Therefore, a sufficiently long time
must be waited before manual intervention in the machine to avoid burns and scalds.
NOTE
Wear chemical protective gloves
Caution: Danger of scalding from 100°C hot oil!
WARNING
Risk of injury due to stored residual energies
The occurrence of mechanical, pneumatic and electrical residual energies on the machine
after operating the unit to stop it in an emergency or after switching off the machine must be observed!
