Foreword
Planetary gear unit LPxxx
6
Version: 1.6
1.2
Documentation issue status
Version
Comment
1.6
Chapter update:
Disposal
4.5
, Important notes
9.1
; Guide for commissioning of the gear units
9.2
1.5
Chapter update:
1.0 Foreword; 3.0 Safety
1.4
Chapter update:
11.2; 13.1
Deleted chapters:
9.0; 10.0; 11.0; 12.0
1.3
Chapter update:
8.1; 8.2; 8.3; 8.4; 8.5; 12.1; 12.2; 12.3; 12.4; 12.5; 12.6; 12.7
1.2
Chapter update:
7.2; 11.3.1; Layout revision
1.1
General revision
1.0
First edition
1.3
Intended use
The gear unit is used for transforming torques and speeds. It is suitable for all industrial applications that are
not covered by Article 2 of EC Directive 2002/95/EC (restriction of the use of certain hazardous substances
in electrical and electronic equipment).
The gear unit must not be operated in potentially explosive atmospheres. In food processing applications,
the gear unit may only be used beside or below the food area.
The gear unit is intended for mounting on motors that:
• match type B5 (if different, please contact our service department);
• have a radial and axial run-out tolerance of at least "N" according to DIN 42955;
• have a smooth shaft.
NOTE
Damage from improper use
Any use exceeding the maximum permissible speeds, torques and temperature is considered improper and
is therefore not permitted.