Commissioning
CP39xx-14xx-0010
28
Version: 1.1
Installing the mounting arm adapter with tilt adapter C9900-M764
To fasten the mounting arm adapter with tilt adapter to the Control Panel, follow the steps below, shown in
Figs. 20 - 24:
1. Release the four M4 screws of the side cover (section A).
2. Slide the C9900-M759 adapter onto the C9900-M735 tube adapter and feed the cables out the side of
the mounting arm adapter (section B).
3. Grease the set screw with the PTFE paste supplied (section C).
A
B
C
J
L
K
M
H
I
Fig. 20: CP39xx-14xx-0010_installation of mounting arm adapter with tilt adapter
4. Release the four M5 screws of the connection plate (section D).
5. Position the tilt adapter on the connection section of the Control Panel and tighten the six M5 screws
supplied with a tightening torque of 4 Nm. (section E).
D
E
Fig. 21: CP39xx-14xx-0010_installation of mounting arm adapter with tilt adapter
6. Fasten the four M5 screws of the connection plate (section F).
7. Use the bolt plates provided for temporary mounting (section G).
F
G
Fig. 22: CP39xx-14xx-0010_installation of mounting arm adapter with tilt adapter
