General Notes
Operator's obligation to exercise diligence
The operator must ensure that
•
the Control Panel is only used for its intended purpose (see
section);
•
the Control Panel is only operated in a sound condition and in
working order;
•
the instruction manual is in good condition and complete, and
always available for reference at the place of installation of the
Control Panel;
•
the Control Panel is operated, maintained and repaired only by
suitably qualified and authorised personnel.
•
the personnel is instructed regularly about relevant occupational
safety and environmental protection aspects, and is familiar with
the operating manual and in particular the safety notes contained
herein.
•
none of the safety and warning notes attached to the Control Panel
are removed, and all notes remain legible.
National regulations
depending on the machine
type
Depending on the type of machine and plant in which the Control Panel is
used, national regulations governing the controllers of such machines will
apply, and must be observed by the operator. These regulations cover,
amongst other things, the intervals between inspections of the controller.
The operator must initiate such inspections in good time.
Procedure in the event of a
fault
In the event of faults at the Control Panel, the list in the section
can be used to determine the measures to be taken.
Operator requirements
Read the operating
instructions
Anyone who uses the Control Panel must have read these operating
instructions.
Software knowledge
Every user must be familiar with any of the functions of the software
installed on the PC that he can reach.
UL-Certificate of Compilance
We herewith confirm that the Control Panel CP78xx of Beckhoff
Automation GmbH meets the requirements of the Underwriters
Laboratories Inc.
®
(UL)-standard:
Certificate Number:
280607 – E220403
Report Reference:
E220403, April 16th, 2007
Issue Date:
2007 June 28
Standards for Safety
The correspondance of the mentioned product with these requirements is
proved by the fact that this product meets with the following single
standards:
•
UL 60950-1, 1st Edition, 2006-07-07 (Information Technology
Equipment – Safety - Part 1: General Requirements)
•
CSA C22.2 No. 60950-1-03, 1st Edition, 2006-07 (Information
Technology Equipment - Safety - Part 1: General Requirements)
4
CP78xx
