Mounting and wiring
CPX39xx-0010
24
Version: 0.1
5.2
Wiring
5.2.1
Preparation and protective earthing
CAUTION
The mains plug must be disconnected
Please read the documentation for the external devices prior to connecting them!
During thunderstorms, plug connector must neither be inserted nor removed!
When disconnecting a plug connector, always handle it at the plug. Do not pull the cable!
CAUTION
CU8803-0000 disconnect power supply
If using the CP-Link 4 – One Cable Display Link, the 24V power supply of the CP-Link 4
transmitter box must be switched off before disconnecting the CP-Link 4 output connection.
Connecting cables
The connections are located at the back of the Control Panel and are documented in the chapter Interfaces.
When connecting cables to the Control Panel, please adhere to the following order:
• Disconnect the Control Panel from the power supply.
• Connect all cables at the Control Panel and at the devices to be connected.
• Ensure that all screw connections between connectors and sockets are tight!
• Reconnect all devices to the power supply.
Protective Earthing
Malfunction possible with missing ground connection
A proper ground connection of the device is absolutely necessary for the correct function of the
touchscreen.
The low resistance protective earthing connection of the Panel PC is established via the screw connection,
which is located in the connection area.
A wire cross-section of min. 4 mm
2
is required.
Summary of Contents for CPX3915-0010
