Access from the user program
KL3208, KL3228/KS3228
43
Version: 3.3.0
R19: Manufacturer scaling - offset
This register contains the offset of the manufacturer scaling. It can be activated by
feature register.
R20: Manufacturer scaling - gain
This register contains the gain of the manufacturer scaling. It can be activated by
in the feature
register.
R21: Offset register for two-wire connection
The value of register 1 at short cR1-RL1 or +R2-RL2
R23: Reference calibration value: Offset
This register contains the reference value of the calibration, which is determined during the vendor
calibration.
R24: Reference calibration value: Gain
This register contains the reference value of the calibration, which is determined during the vendor
calibration.
R31: Code word register
• If you write values into the user registers without first entering the user code word (0x1235) into the
code word register, the terminal will not accept the supplied data.
• If you write values into the user registers and have previously entered the user code word (0x1235) in
the code word register, these values are stored in the RAM registers and in the SEEPROM registers
and are therefore retained if the terminal is restarted.
The code word is reset if the terminal is restarted.
R32: Feature register
The feature register specifies the terminal's operation mode.
Bit
R32.15
R32.14
R32.13
R32.12
R32.11
R32.10
R32.9
R32.8
Name
SensorType
disChannel -
-
-
Bit
R32.7
R32.6
R32.5
R32.4
R32.3
R32.2
R32.1
R32.0
Name
-
-
Resolution -
-
disWdTimer enManScal enUsrScal
