MD3150/3060
Copyright BEGLE GmbH, All rights reserved.
Page 4
Internet: www.bue.de
Controls
The thermometer has 4 keys on the top side. When power is supplied, the thermometer
adopts default mode 0 and displays the temperature
if the sensor is connected.
Other functions are accessed by pressing the „Mode“ key.
Displays
If while the thermometer is in use the ‘Low Bat’ signal is detected, the ‘Bat’ symbol in the
LCD starts blinking. If the ‘Low Bat’ signal is detected when the thermometer is switched on,
only the blinking ‘Bat’ symbol is displayed. The thermometer can only be switched off in this
state. Please replace the battery without delay.
Spent batteries must be disposed as hazardous waste.
Connecting the MD3150
The temperature measuring instrument
has two different connections:
•
for 8-pin MINI-DIN plug
This connection can be found on the
front of the temperature measuring
instrument (see figure).
•
9V block battery (battery compartment
on rear side)
Connecting the MD3060
The temperature measuring instrument
has three different connections:
•
for 8-pin MINI-DIN plug
•
for Ni/CrNi temperature sensor
These connections can be found on
the front of the temperature
measuring instrument (see figure).
•
9V block battery (battery compartment
on rear side)
Large display
Mode
Small display
Battery
depleted
Function keys
