MD3150/3060
Copyright BEGLE GmbH, All rights reserved.
Page 6
Internet: www.bue.de
Operating modes
Mode 0:
Temperature indication and interface output
Mode display
Small display
Large display
0
Current
temperature
The current temperature value is displayed in this mode.
In addition, temperature values can be output via the serial interface in this mode. A
condition is that the
small display
is 'ON' in mode 1 of the device.
If the measurement is taken on-line, note that the automatic switch-off function 'AoFF'
is 'OFF' in mode 7 of the device.
Only MD3150:
Press the plus key to select the required measuring channel.
C1, C2 -> displays the temperature of measuring channel 1 or measuring channel 2
C12
-> temperature display alternates between both channels every 2 seconds
Press the minus key to change the temperature display between units of °C and °F.
Mode 1:
Switching the serial interface on/off, output of
measured values in the memory
Mode display
Small display
Large display
1
ON or OFF
If
the
small display
is 'ON', briefly pressing the minus key causes output of the
measured values in the memory via the interface.
At the same time the measured values can also be viewed in the temperature display
and the
small display
always shows the appropriate memory location number.
Pressing the minus key again while measured value data is output stops the output.
Pressing the plus key enables (ON) or disables (OFF) the output of measured values
via the interface.
If 'ON' measured value data output is continuous (in mode 0) via the interface (at a
frequency of about 1 value per second).