Beckoff PS2001-2410-0000, Documentation

Technical data, mounting, wiring

PS2001-2410-0000

24

Version: 1.0

3.15

Protective functions

Protective functions

Output protection

Electronically protected against overload, no load and short circuits. If the electronic output
fuse is activated, an audible noise may occur.

Output overvoltage protection

Typ. 30.5Vdc
Max. 32Vdc

In the event of an internal power supply fault, a redundant circuit
limits the maximum output voltage. The output switches off and au-
tomatically tries to switch on again.

Protection class

IP 20

EN/IEC 60529

Ingress protection

> 4mm

e.g. screws, small parts

Overtemperature protection

Yes

Output shutdown with automatic restart. The temperature sensor is
installed at critical components within the device and switches off
the device in safety-critical situations (e.g. load reduction require-
ments not met, excessive ambient temperature, ventilation blocked
or load reduction not observed if the mounting direction is different).
There is no correlation between the operating temperature and the
switch-off temperature, since the latter depends on the input volt-
age, the load and the installation type.

Protection against input transients

MOV (metal oxide varis-
tor)

For further information see 

EMC chapter [

}

 22]

Input fuse

Included

Non-replaceable slow-blow fuse with high load capacity

3.16

Safety features

Safety features

Input/output isolation

Double or reinforced electrical isolation

SELV

IEC/EN 60950-1

PELV

IEC/EN 60204-1, EN 62477-1, IEC 60364-4-41

Protection class

I

PE (protective conductor) connection required

Insulation resistance

> 500MOhm

Under given conditions between input and output, measured with
500Vdc

> 500MOhm

Under given conditions between input and protective conductor,
measured with 500Vdc

> 500MOhm

Under given conditions between output and protective conductor,
measured with 500Vdc

> 500MOhm

Under given conditions between output and DC OK contacts, mea-
sured with 500Vdc

PE resistance

< 0.1Ohm

Resistance between the protective conductor connection and the
housing near the DIN rail mounting bracket.

Leakage current

Typ. 0.14mA / 0.36mA

At 100Vac, 50Hz, TN, TT / IT network

Typ. 0.20mA / 0.50mA

At 120Vac, 60Hz, TN, TT / IT network

Typ. 0.33mA / 0.86mA

At 230Vac, 50Hz, TN, TT / IT network

Max. 0.18mA / 0.43mA

At 110Vac, 50Hz, TN, TT / IT network

Max. 0.26mA / 0.61mA

At 132Vac, 60Hz, TN, TT / IT network

Max. 0.44mA / 1.05mA

At 264Vac, 50Hz, TN, TT / IT network