EN
16
4
Preparation
t
Your refrigerator should be installed
at least 30 cm away from heat
sources such as hobs, ovens, central
heater and stoves and at least 5
cm away from electrical ovens and
should not be located under direct
sunlight.
t
The ambient temperature of
the room where you install your
refrigerator should at least be
10°C. Operating your refrigerator
under cooler conditions is not
recommended with regard to its
efficiency.
t
Please make sure that the interior
of your refrigerator is cleaned
thoroughly.
t
If two refrigerators are to be
installed side by side, there should
be at least 2 cm distance between
them.
t
When you operate your refrigerator
for the first time, please observe the
following instructions during the
initial six hours.
t
The door should not be opened
frequently.
t
It must be operated empty without
any food in it.
t
Do not unplug your refrigerator. If
a power failure occurs out of your
control, please see the warnings in
the “Recommended solutions for
the problems” section.
t
Original packaging and foam
materials should be kept for future
transportations or moving.
t
The baskets/drawers that are
provided with the chill compartment
must always be in use for low energy
consumption and for better storage
conditions.
t
Food contact with the temperature
sensor in the freezer compartment
may increase energy consumption
of the appliance. Thus any contact
with the sensor(s) must be avoided.
t
In some models, the instrument
panel automatically turns off 5
minutes after the door has closed.
It will be reactivated when the door
has opened or pressed on any key.
t
Due to temperature change as
a result of opening/closing the
product door during operation,
condensation on the door/body
shelves and the glass containers is
normal
