CUT
HERE
Height
Needed
Height
Needed
4
EASY ASSEMBLY AND INSTALLATION
ReadyLadder solutions are designed for easy installation using ordinar y tools. Your ReadyLadder
shipment will include the ladder sections, standoffs, hardware, connectors, and base brackets.
ASSEMBLY INSTRUCTIONS
TIP
Assemble your ladder on the ground, then put it into position for installation.
To determine the height of your
assembled ladder, decide where you
want the top rung positioned and
measure straight down to the floor.
Measure the overall ladder from
the ver y top rung to the height
you need and cut off any excess
from the bottom where it’s going
to touch the floor. Note that the
top of the bottom rung must be
between 2"–14" to comply with
OSHA standards. If needed,
use the ladder extension kit to
ensure the top rung height is
correct and bottom rung height
is OSHA compliant.
If joining sections to achieve desired height:
Insert and bolt the connectors into the
bottom of each ladder section, except for
the section that’s going to touch the floor.
Stand up the ladder and mark the
positions for the standoffs. The
top standoffs should be placed
just below the top rung; remaining
standoffs should be spaced no
more than 6' apart.
If joining sections to achieve desired height:
Slide the ladder sections together by
inserting the connectors into the top of each
ladder section; no bolts are needed since
gravity will ultimately hold them together.
If not joining sections, skip steps 2 & 3.
Drill holes in the ladder rails
1/16" larger than the supplied
bolts, then secure the standoffs
to the ladder. Torque the bolts to
60 in./lbs.; don’t overtighten.
With the ladder in its final position,
install the anchor clips by placing them
against the ladder rail and drilling
through. Use a bolt to secure each clip.
Use the anchor bolt to secure the clip to
the ground.
1
4
2
5
3
6
7
The photographs and/or drawings in this literature are for illustrative purposes only. While every reasonable effort has been made to ensure the accuracy of this data, we are not responsible for any errors or omissions contained
on these pages. Please verify any information in question with a Bedford sales representative. We reserve the right to make changes in specifications without notice and without incurring obligation.
© 2021 Bedford Reinforced Plastics. All rights reserved. v02052021
BEDFORD REINFORCED PL ASTICS :
ONE CORPOR ATE DRIVE, SUITE 106, BEDFORD, PA 15522 USA
Questions?
The ReadyLadder team is always happy to help. Give us a call at 814-623-8125 or visit readyladder.com.
No more
than 6ft
If your system included fall protection and/or walk throughs, additional instructions will be provided.
