HART Device Configuration
Chapter 5
10/11/18
Bedrock Secure OSA Remote User Manual - BRDOC020_001
47
Figure 5-9 Select and Scan Controller-Local Interconnect Gateway DTM in Network View
11. Add a gateway DTM for SIO-Hart. The gateway DTM can be added
either automatically or manually. Choose one of the following.
•
To automatically add a gateway DTM for SIO-Hart, click Scan
and Select on the Ribbon as shown in Figure 5-9. The Bedrock
FDT will query the network for available Bedrock Secure OSA
Remotes. Go to step 12.
•
Or
to manually add a gateway DTM for SIO-Hart to your
network topology without querying the network, click the plus
sign next to the DTM in the Device Catalogue that is named
“Bedrock SIO-Hart 6.20 ANALOG”. Go to step 13.
12. If you elected to automatically add a DTM (Scan and Select) in the
previous step, a list of the DTMs that were found will be displayed as
shown in Figure 5-10. Select the checkbox for the “Bedrock SIO-Hart
6.20 ANALOG” DTM and then do one of the following:
•
Click Add All and Close. This will add the selected DTM to
your project.
•
Or
click Add Selected Nodes to Project. This will add the
selected DTM to your project. Click Close to dismiss the
dialog.
