Chapter 4
Configuration and Status
34
Bedrock SPS.500 User Manual - BRDOC125_007
9/3/21
Table 4
-
8 lists the index values for the Configuration Change event.
Logged Faults
The faults listed in Table 4
-
9 are logged by the SPS. The fault name and fault
data appear in the log entry.
Table 4
-
8 SPS.500 Configuration Change Event Index Values
Index Value
Configuration Parameter Changed
0
SPS On
2
Output Voltage
3
Overcurrent Limit (Rev A Only)
5
”OR”ing Controller On
7
Relay Control A
8
Relay Control B
9
SPS Auto Start On
10
Overcurrent Warn
11
Overcurrent Latch-off
12
Retries
13
Log Snapshot Interval
15
DC Overcurrent Limit (SPS.500 revision B or later)
16
”OR”ing Overcurrent Limit (SPS.500 revision B or later)
17
Total Overcurrent Limit (SPS.500 revision B or later)
18
“OR”ing Overcurrent Warn (SPS.500 revision B or later)
19
Total Overcurrent Warn (SPS.500 revision B or later)
Table 4
-
9 SPS.500 Logged Faults
Fault Name
Fault Reason
Additional Fault Data
Input Under Voltage
The input voltage has fallen below the
operational requirement.
Input voltage in volts
Internal Fault
An internal power conversion fault has
been detected
None
Output Overcurrent
The load on the output is greater than the
configured DC Overcurrent Limit
Output current in amps
Input Frequency out of
Range
The frequency for the input is out of range
for the operation
Input frequency value in hertz
Image Update Validation
Failed
Failed validation of uploaded firmware
update
IPv6 address of the client that requested
the image update
Output Latched Off
During an overcurrent condition, the
SPS.500 output turned off due to the
number of retries being exceeded
None
