DANGER: Stay clear of rotating driveline. Entanglement in rotating driveline can
cause serious injury. Disengage PTO, engage parking brake or place
transmission in “Park”, shut off the tractor and remove the key before
working
around hitch, attaching or detaching driveline, making adjustments, servicing or
cleaning the machine.
3.05 - Attaching to the Tractor
Unit may be used on tractors ranging from 20 to 50 HP equipped with a standard PTO
and category 1 three point hitch
5
.
Never use this tedder with tractors over 50 HP.
CAUTION: Check the tractor PTO rpm to ensure it is set at 540
and turns
clockwise.
CAUTION:
Never attempt to attach the tedder to the tractor or make any
adjustments to it without first turning the tractor off.
DANGER: Failure to ensure a secure coupling of the implement to the tractor can
cause injury and damage to the implement or tractor.
If necessary, wheel weights,
front tractor weights and/or tire ballast should be used to improve stability. Be
sure that the tractor tire pressure is correct. It is important to strictly follow the
safety guidelines and instructions laid out in the tractor’s operator’s manual.
To attach the tedder to the tractor do the following:
1. On tedder model DR0-330, back the tractor up to the tedder in order to slip the
tractor hitch arms over the hitch pins on the tedder hitch arms.
Turn off the tractor
engine.
Secure them in place with the lynch pins. Adjust the tractor sway blocks or
chains to remove all side movement. Attach the top link. Make sure wheel locks are
disengaged before operating the machine
(see fig. 15)
.
2. On tedder model DRP-330, position the tractor drawbar
(see fig. 11)
. Remove the
hitch pin. Align hitch pin holes in tractor drawbar and tedder. Install hitch pin and
fasten it with a cotter pin.
3. Install the shielded driveline to the tractor by first lining up the splines and
depressing the snap pin. Push the yoke onto the PTO shaft as far as it will go.
Release the pin and pull back slowly until the pin clicks in place. Repeat this
operation on the implement end. Be sure to install the ratchet torque limiter side of
the PTO shaft on the implement.
O
PERATION
17
BEFCO
R
OTARY
T
EDDERS
O
PERATOR
’
S
M
ANUAL
5
See Table 2, page 29.
Summary of Contents for DR0-330
Page 36: ......
Page 40: ...ROTARY TEDDERS RIGHT FRAME OPERATOR S MANUAL DR0 330 DRP 330 PARTS MANUAL 40 BEFCO 01 2012...
Page 54: ......
