Page 13 of 14
Cr
Mai
n l
oa
di
ng p
oin
t
Be sure the distance between
main loading and Cr must be
more than 150 mm.Please
contanct the child restraint
manufacturer if in doubt about
this point.
4.3 Main loading point
If you want to release the child seat:
Step 1: Open the buckle of vehicle seat belt.
Step 2: Take out the vehicle seat belt from the guide hooks of child seat.
Notice: Child seat for group II/III shall be used without headrest
cushion and seat cushion.
5. Removing and
fi
tting of seat cover
1. Open the buckle of child seat.
2. Remove harness straps and buckle following operation of 3.11.
3. Take off the headrest cushion and seat cushion.
4. Open the buttons on the backrest, and then take off the cover.
6. Daily Care and Maintenance
1. In the daily using, you need to check the wear and tear situation of
the child seat.
2. The child seat should be kept in a dry, ventilated and cool place when
it is not used.
3. If the child seat is dirty, you can use the wet sponge to clean the
Y-shaped straps, buckle or cover.
4. Washing instructions are listed as below:
Hand washing ,
below 30
degrees
Do not
iron
do not
bleach
dry clean any
solvent except
trichloroethylene
Do not
tumble dry