Bego 26490, Translation Of The Original Operating Instructions

English 

⋅

 VARSEO XS

7

86

10

9 B

A

-en

/0

1

en

Safety Instructions

The BEGO VARSEO XS is based on DLP 
technology (Digital Light Processing) and is 
intended solely for the creation of objects from 
stereo lithography resins, which have been 
approved by BEGO. Any other use is deemed to be 
improper. We shall not be liable for any damage 
resulting from improper use.
The safety instructions must be adhered to in order 
to prevent personal injury and damage to the 

device. We shall not be held liable for any damage 
arising from the failure to comply with the safety 
instructions.

General Safety Instructions

Place of installation - 

The device has been 

designed solely for use in institutions such as 
research, commercial and training facilities.
The device may only be installed on a sufficiently 
stable surface. The height of the table should not 
exceed 720 mm to avoid posture problems.
The device should only be used in 

dry, dust free 

and well ventilated

 rooms.

Keep the 3D printer away from direct sunlight and/or 
UV light even when the cover is closed.
Make sure that the device is not exposed to vibra-
tions during operation. For that reason, do not place 
the device next to other devices that may generate 
vibrations.

Operating company and operating person-
nel - 

The device must only be operated by trained 

specialists; trainees and other persons operating 
the device must be supervised..
Operators must wear the prescribed protective 
clothing and comply with the rules of conduct.
The device must only be operated by employees, 
who are familiar with and follow the instructions of 
this operating manual.
The operating manual must be easily accessible 
during the operation of the device. Observe the 
national accident prevention regulations in addition 
to this operating manual.

Handling the device - 

Prior to connecting the 

device to the power supply, check and make sure 
that the specifications on the rating plate corre-
spond to the power supply network. Consult a 
specialist in case of uncertainty.

The device is subject to the provisions of protection 
class III and must only be connected to proper 
power sources (outlet sockets).
The device must not be modified.
Signs and labels must always be maintained in 
legible condition. They must not be removed.
The device and its supply lines must be checked 
regularly for signs of damage. The device must not 
be operated if it has any defects that may pose a 
risks for the employees or third persons.
The operation of the device requires a LAN or WIFI 
connection, which must be set up beforehand!
Supply lines must be protected against heat, oil and 
sharp edges. Supply lines must not be used to carry 
the device or to pull out the mains plug.

Repairs - 

Repairs must only be carried out by 

BEGO customer service personnel or by persons 
authorized by the BEGO customer service 
department.

Care and maintenance - 

Switch off the device 

and pull out the mains plug before performing any 
servicing, cleaning or maintenance work.
Only use dry or slightly damp cloths to clean the 
device. The device must not be sprayed with or 
immersed in water.
Cleaning the resin tank 

→

page 35

WARNING

Risk of injury!

Observe the safety data for the resin 
used!