English
⋅
Nautilus
®
T
65
A
en
6.
Insert the mould as quickly as possible after
the preheating process has been completed.
7.
Close the mould door.
The next display is shown when the mould
door is closed.
8.
Confirm the melting process by pressing the
"OK" button or skip it by pressing the "Abort"
button.
The NAUTILUS
®
T shows a video of the pro-
cess on the display.
9.
Enter the additional heating time for melting
(see the table on page 35) using the "+" and "-"
buttons.
Once activated, the timer will count down the
entered seconds and thus determines the time
to cast. The timer should be activated as soon
as all the alloy components have melted
together.
WARNINGS
Risk of burn injuries!
Use mould tongs!
WARNINGS
Never look into the melt without
protective glass and protective
eyewear!
NOTE
If no video image is shown on the screen, the
message "Temperature too low" will appear. As
soon as the camera detects an image, it is trans-
ferred to the display!
Summary of Contents for 39701001
