3
1. Installation of the 3D Printer
Please install the Anycubic* Photon Mono X 3D printer according to
the manufacturer‘s instructions (see instructions for use).
Recommendations:
•
Place the 3D printer in an area protected from direct sunlight and
dust
•
Set the light intensity on the printer to 100%:
Menu Tool Settings (cog at the top right of the image)
Enter 100 % Enter
•
Calibrate the stamp: follow the steps in the instruction manual
• Make sure that the protective foil of the resin tray is
is removed
• Tighten the screws of the stamp evenly in diagonally opposite
order
* This symbol is a commercial designation/registered trademark of a company which is not part of the BEGO company group.
Pictures and illustrations are exemplary. Colors, symbols, design, and information on the labels and/or packaging shown may differ from reality.
